Equipment
-
$0.50Silicone Washer Seal - 5/8 for Keg Coupler and Tap Shank
A 5/8" silicone washer seal for Keg Coupler or Tap Shank.
Note: may come in black or white/clear.
Silicone washer seals are easier to get a proper seal but are also easier to damage. If you are looking for a more robust solution consider using a 5/8" neoprene washer instead. -
$4.00Wing Nut for Beer Shank
Chrome plated brass wing nut, often used for attaching a tail piece to a shank. A handy alternative to the standard 5/8" hex nut if you have an application where you wish to be able to disassemble the shank tail piece without using a wrench. -
$23.50Super Automatica Tirage Bell - 29/31mm (large)
For use on the Red handle "Super Automatica Capper" with Tirage Bells. The standard bell supplied with the Super Automatica Capper is 26mm. This larger 31mm bell is compatible with slightly larger caps and bottle tops.
IMPORTANT: This bell is NOT compatible with the "Green Standard Bench Capper" OR "Lever Bench Capper" - due to different thread size.
-
$12.95Push In Pressure Gauge - 8mm
This push in gauge is ideal to read pressures during pressurised fermentation. The triple scale gauge gives readings in Bar, PSI and kPA so irrespective of what units you prefer this gauge will display what you need.
The barb on this gauge will enable you to put this directly onto hosing or alternatively you can connect it to any of the push in fittings such as the Duotight push in fittings in the 8mm size.
Specifications:
- 0-40psi / 0-250kPa / 0-2.5 Bar (kg/cm^2)
- Rubber Coated
- 8mm Push in Barb
From: Kegland -
$64.955L Propylene Glycol - Kegland
Food grade Propylene Glycol (99%) from Kegland in a handy 5 litre container.
Out of Stock -
$1.00Thermowell and FTSs Chiller Coil - Ss Replacement O-Ring
Ss Replacement O-Ring for SS Brewtech Thermowells and FTSs Chiller Coils.
From: Ss Brewing Technologies, USA
A cheap, small but critical part of your brewkit, don't let a damaged o-ring spoil your brewday. -
$9.50Sterilock Air Lock (with one odour capsule)
The Sterilock contains a patented nanoseal that removes fermentation odours and allows C02 gases to safely vent while preventing any contaminants (including bacteria) to enter the fermentation vessel.
-
$9.50Sterilock Odour Capsules (4)
For use with the Sterilock Airlock Contains 4 odour absorbing capsules to remove fermentation odours.
Out of Stock -
$49.95FermZilla - Jacket for 27L
This jacket is designed to insulate your FermZilla 27L fermenter during the colder months to keep your fermentation at the optimum temperature.
It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.
Completely blocks any light/UV to prevent light-stuck beer.
Also compatible with 60L All Rounder
From: Kegland
-
$59.00Spunding Valve KIT (with push in gauge) 15psi
This is a must have product if you own a FermZilla or Fermentasaurus and would like to ferment under pressure. With this you can regulate the pressure & therefore carbonation of your fermenter/beer by adjusting the maximum pressure you want it to contain.
Watch this video on assembly & operation details:
