Complete with swivel head and a tapered thread that is compatible with "English" style fermentation barrels. Available in white only.

This is not compatible with the standard 30L plastic fermentation buckets available in NZ.

Tap. Italian Barrel & Locknut (med.spigot). As this tap has a backing locknut and two rubber washers, it is suitable for those looking to mount a tap in any plastic vessel once you have drilled a suitable size hole.

Silicone Stopper for Ss Brew Buckets and Chronicals, made from food grade silicone.

DIY Tap Handle Inserts - Dual Threaded - 3/8″-16 threads, .625″ Length.

Want to make your own unique tap handles but the thread type is strange? These simplistic brass inserts are the answer.

All you'll need is a 12.7mm (1/2") hole drilled into your handle (Pine, Red Gum, Oak, Cherry, Maple, etc), then screw in with a large flat screw driver.

It is important not to push down too hard if you're going to using a screw driver, or wide drill bit. It will strip the thread. Let the piece cut into the wood. Ensure that it is straight.

Suits NukaTap and Intertap taps

 

This Nukatap mini & Nukatap FC spring is designed to suit all Nukatap Mini taps and also the Nukatap Flow Control (FC) tap.  This custom made 304 grade spring size is designed specifically to ensure your Nukatap stays closed when it should.

Simple let go of the tap handle and the tap will snap shut and prevent accidentally leaving the tap on and emptying the keg onto the floor.

Blow Off Barb For FTSs and Ss Brew Bucket Lids.

- Custom tooled specifically for FTSs/Brew Bucket lids
- Fits into blow off / airlock hole
- 1/2" hose barb
- 304 Stainless construction
- Includes 1 spare o-ring (1 o-ring for use / 1 spare)

Leg Extensions for Ss Brew Tech Chronical 52L and Chronical 64L fermenters.

- Made from 304 Stainless Steel
- Finish matches Chronical legs
- 3/8" male stem on top (insert to legs)
- 3/8" female on bottom (for casters/feet)
- Approx. 25cm (10") total length

Sold as a set of four.

A carbonation stone designed with a removable and replaceable carb stone. Ideally suited to Ss Brewtech unitanks up to 1bbl.

• 1.5" Tri-Clamp 
• 3/8" Hose barb valve
• 0.5 Micron stainless steel carb stone

Note: it needs a minimum 19mm inner diameter tee to be used in an oxygenation kit.

A replacement ball valve and racking arm for Ss Brew Tech Brew Buckets.

Features:
- 3/8" Mini Ball Valve
- 304 Stainless Steel
- racking arm
- all O-rings included