This jacket is designed to insulate your FermZilla 27L fermenter during the colder months to keep your fermentation at the optimum temperature.

It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.

Completely blocks any light/UV to prevent light-stuck beer.

Also compatible with 60L All Rounder

From: Kegland

Stainless steel Tail Piece for your beer shank or coupler

From: Krome Dispense
Material: 304 grade stainless steel

You may also need a hex nut or wing nut, and neoprene washer - available separately.

Stainless steel elbow Tail Piece for your beer shank or coupler

From: Krome Dispense
Material: 304 grade stainless steel

You may also need a hex nut or wing nut, and neoprene washer.

Our standard bench capper provides an easy way to cap your beer bottles.

It is made from steel and with rubber grip pad so your bottles don't slip off the platform

This bottle capper can be used on different size bottles as the hight of the bell can be adjusted, and it can be bolted to sturdy surface.

Features:
- Easy to use and adjust to required heights depending on bottle size
- Comes with a standard bell which has a built in magnet to hold the bottle cap
- Simply place bottle caps in the bell then place the bottle underneath and pull the handle down

The capper is shipped flat-packed and needs assembling before use.

The Temp Twister allows you to heat and cool your FermZilla or other fermenter or bright tank, ideally by combining with a glycol chiller.

This coil can be adapted to fit any fermenter or bright tank that has an opening of 110mm diameter or larger. Simply drill to two 22mm holes in the lid of your fermenter and use the included Duotight bulkhead fittings to attach the coil to the lid of your fermenter.

Floating Dip Tube Filter

80 Mesh 304 Stainless - For FermZilla or Kegmenter.

Made from HDPE and 304 Grade stainless steel, this product can be boiled or sanitised in the full range of cleaners that we sell. The plastic HDPE is over moulded onto the stainless mesh to make a seamless finish. The end cap can easily pop off for cleaning.

This unit has been designed to fit our standard Quadruple Tap Kegerator Tower or any other 115mm diameter font. It does not fit 1-3 tap kegerator towers.

Keep your beer icy-cold with this insulated tower/font cover right out of the first drop. Most kegerators that we sell include a font fan that blows cold fridge air up the font. With that said heat loss from the stainless font surface causes the font temperature to rise meaning that a small amount of beer contributes to the "first pour foam effect".

Replacement seal kit for the FermZilla 27L and 55L Conical Range

Lid O-ring Also suits the Fermzilla Flat Bottom and All Rounder (for Lid O-ring)