For use on the Red handle "Super Automatica Capper" with Tirage Bells. The standard bell supplied with the Super Automatica Capper is 26mm. This larger 31mm bell is compatible with slightly larger caps and bottle tops.

IMPORTANT: This bell is NOT compatible with the "Green Standard Bench Capper"  OR "Lever Bench Capper" - due to different thread size.

This push in gauge is ideal to read pressures during pressurised fermentation. The triple scale gauge gives readings in Bar, PSI and kPA so irrespective of what units you prefer this gauge will display what you need.

The barb on this gauge will enable you to put this directly onto hosing or alternatively you can connect it to any of the push in fittings such as the Duotight push in fittings in the 8mm size.

Specifications:
- 0-40psi / 0-250kPa / 0-2.5 Bar (kg/cm^2)
- Rubber Coated
- 8mm Push in Barb

From: Kegland

Food grade Propylene Glycol (99%) from Kegland in a handy 5 litre container.

The Sterilock contains a patented nanoseal that removes fermentation odours and allows C02 gases to safely vent while preventing any contaminants (including bacteria) to enter the fermentation vessel.

For use with the Sterilock Airlock Contains 4 odour absorbing capsules to remove fermentation odours. 

This jacket is designed to insulate your FermZilla 27L fermenter during the colder months to keep your fermentation at the optimum temperature.

It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.

Completely blocks any light/UV to prevent light-stuck beer.

Also compatible with 60L All Rounder

From: Kegland

Stainless steel Tail Piece for your beer shank or coupler

From: Krome Dispense
Material: 304 grade stainless steel

You may also need a hex nut or wing nut, and neoprene washer - available separately.