Kegging
-
$5.00Duotight Push Fit Tee connector 8mm
This push-fit T-Connector will split the gas (or beer) line on your kegging system in two, allowing you to gas two kegs at the same time. Simple to use and requires no tools. -
$9.00Tail Piece with 1/4" MFL Connector
Tail piece for your dispensing system that provides a 1/4" MFL connector instead of a barb.
From: Krome Dispense
Material: 304 grade stainless steel
Looking for the full setup? Designed to be used with a 5/8" hex nut and a 5/8" neoprene washer. These items sold separately. -
$5.00Duotight - 8mm Push-Fit Check Valve
Duotight 8mm (5/16) one way check valve/non-return valve.
From: Kegland -
$5.00Duotight - 8mm Ball Valve
Duotight - 8mm shut off ball valve. This is an equal ball valve to take 8mm OD tubing in both sides.
No clamps necessary!
From: Kegland -
$4.95Duotight Push In For MFL Connector - 8mm
Easily connect your beer or gas line to your MFL fitting.
Note: MFL keg connector and tubing sold separately.Brand: Duotight
-
$6.30 -
$4.95Duotight - 6.35mm x 8mm Reducer
No clamps necessary, however we do recommend cutting your hosing straight, not on an angle, to ensure the line has a complete seal. To remove the fitting simply push in the collect and the hose can be removed.
These push in fittings are suitable to be used up to 100 psi.
No clamps Necessary!
Out of Stock -
$15.50PRV Fitting for Kegging
Pressure Relief Valve (PRV) fitting for connecting onto a gas post so that you can release pressure while controlling the fill speed when transferring beer from one vessel to another.
-
$16.95Gas Free Ball Lock - PET Party Pump Combo - PCO1881
Are you ever in a situation where you don't want to unhook your gas line from your kegs, or have ball lock disconnects that you need to clean over at the sink but don't want to take your gas line all the way over there? Well, Kegland thought of a better way. Why not fill a PET Bottle with your cleaner / sanitiser and pump it without gas!
This little device can also be used as a mini party keg without a gas source (should be consumed well within 24 hours of pumping). BYO Liquid disconnect, hose and picnic tap. -
$12.95MFL Check Valve
An MFL Check Valve to prevent backflow, with 1/4″ FFL outlet x 1/4″ MFL Inlet.
Use this check valve on ball lock gas connectors with MFL thread. Its internal mechanism prevents accidental back-flow of beer into the gas line on your kegging set up.
