Equipment
-
SIlicone check Valve for D&S coupler
SIlicone check Valve for D&S couplers.
For the larger type check valve see here -
Probe Seal Washer for Keg Coupler - D Type - No.4
Gas shut off probe (Keg Coupler Probe seal o-ring No.4)
Compatible with micromatic and all 'D and S' type keg couplers.
Dimensions 17MM OD X 10MM ID
-
D Type coupler O-ring (Body O-ring) No.5
'D and S' Type coupler O-ring (Body O-ring) No.5
Normally purchased in increments of x 2. (body takes 2 o-rings)
-
Keg Coupler - 90 Degrees D-Type Low Profile - C4999
Keg Coupler - D Type (US Sankey). This is a low profile coupler designed for situations where vertical space is limited.
Includes a pressure relief valve (releases at 55 PSI).
Out of Stock -
Keg Coupler - D-Type Stainless with Duotight Fittings
D-Type Keg Coupler - Full 304 Stainless - with Duotight 5/8" to 8mm push fit fittings.
Includes:
1 x - D-Type Coupler with 5/8" Male Beer and Gas threads
2 x - duotight 5/8" duotight to 8mm push in
1 x - Non-Return Ball or Torpedo check piece (Non-Return Liquid)
1 x - Gas Duck Bill valve (Non-Return Gas) -
Hop Straining Bag (C163)
A reusable hop straining bag made from nylon mesh. Good for steeping hops or dry hopping, or for adding other things like oak chips to your brew. It's also easy to clean and sanitise.
Size: approx 125mm x 220mm
From: Krome DispenseOut of Stock -
MKII 25W High Temperature Magnetic Drive Pump
This pump is constructed of food-grade materials and handles boiling wort with ease. The impeller housing is made from polysulfone as it is a tough, food-grade plastic rated up to 120C. The magnetic drive acts as a clutch allowing the user to put back pressure on the pump to slow down flow without any damage to the pump. Since it is magnetic drive, it’s not self priming, you must put the pump under the level of the liquid source.
-
2 Micron Diffusion Air Stone (barb)
Use this 2 micron stone with an oxygen source or an aeration pump to provide your yeast with oxygen pre-fermentation, or with CO2 to speed up carbonation of the finished beer.
The barb fits 1/4" (6.35mm) ID tubing.
From: Keg KingOut of Stock -
MKII 65w High Temp Magnetic Pump
Pump - MKII 65watt High Temp Magnetic. Note, this is the larger, 65watt model, ideal for large home brew systems and nano breweries.
This pump is constructed of food-grade materials and handles boiling wort with ease. The impeller housing is made from polysulfone as it is a tough, food-grade plastic rated up to 120C. The magnetic drive acts as a clutch allowing the user to put back pressure on the pump to slow down flow without any damage to the pump. Since it is centrifugal, it's not self priming, you must put the pump under the level of the liquid source. -
Stainless Pump Head for MKII Magnetic Drive Pump (25W)
A stainless steel pump head for the 25watt MKII High Temperature Magnetic Drive Pump, with 1/2" BSP threads. Designed as a replacement/upgrade for the plastic pump head that comes as standard with the original pump.
From: Kegland.



