Stainless steel tri-clamp cap (1.5") to 1/4″ (6.35mm) Hose Barb.

• Made out of 304 Stainless Steel
• 1/4″ OD Hose Barb
• Designed for use with 1/4″ ID tubing

A 22mm Hole Plug with o-rings and attachment nut, used to plug thermometer, ball valve, and kettle top recirculation holes on Ss Brewtech kettles.

A stainless steel plate to close, or blank off an outlet. Sometimes it is referred to as a blind cap.

Currently available in these sizes:
- 1.5" (3.81cm)
- 2" (5.08cm)
- 3" (7.62cm)

A 1.5" tri-clamp cap to male camlock adapter.

Tri-Clamp Cap - 6" to 3" Reducer. Great for 10 Gal Brite Tanks or 52/76L Unitanks.

Note: gaskets not included, but you can find them here.

Compatible with any 2 Inch tri-clamp fitting. Primarily designed for the:
- FermZilla 2" Tri-Clamp Lid
- in conjunction with the 2" Tri-Clamp Hop Bong

If you are looking to put your FermZilla Tri-Conical / All Rounder in a Fermentation Chamber / Fridge, you will want to allow 420mm measured from the base of the ring collar to a comfortable level to pull the pressure relief valve to purge oxygen from the hop bong.

A Tri-Clamp fitting made from 304 stainless steel - available in different sizes.

316 stainless BSP 1.5” Back nut. Compatible with the DN40 tri-clamp fitting.