The BrewZilla Gen 4 is designed to be a compact single vessel all grain home brewing system that can be run off a single 220-240v socket. A complete turnkey system with a delay timing feature and step mash functionality. Built to make batches up to 30L, it is the ideal solution for those who want to take the first step in all-grain brewing while also wanting full control of their batch from start to finish.

Fast to setup, brew and clean up is easy The very simple design is easy and intuitive to use.

This handy little device enables you to add clarifier / finings to your beer that is in a pressurised fermenter. You can add your claifier / finings to your beer with no exposure to oxygen whilst still under pressure.

BrewZilla Gen 4 Neoprene Jacket / Parka with Recirculation Arm Cover

New and improved BrewZilla Gen 4 Neoprene Jacket for more stable mash temperatures and heat retention. Now made with 8mm thick neoprene, improved recirculation pipe insulation on both the boiler and the recirculation camlock arm.

If you brew outside where it is cold or windy, the Neoprene Jacket/Parka is a must-buy! Don't lose that heat to the atmosphere!

Available for both 35L and 65L Brewzilla Gen 4 units.

Yay, finally a wider mouth demijohn that will take our easy siphons!

You can get the Stopper without Hole or the Stopper with Hole to fit this demijohn.

Please note these demijohns come with a screw top lid rather than a swing top. The swing tops are not compatible with this demijohn.

Neck internal diameter 40mm

This black HDPE lid has been designed to be chemically resistant but also strong enough to hold up to 2.5bar pressure.

This lid can screw onto the top of your Fermzilla Collection Container and this allows you to use the Fermzilla collection contianer for other stainless fermenters with a 2 inch tri-clamp dump valve.

Note: clamp and container not included.

Compatible with any 2 Inch tri-clamp fitting. Primarily designed for the:
- FermZilla 2" Tri-Clamp Lid
- in conjunction with the 2" Tri-Clamp Hop Bong

If you are looking to put your FermZilla Tri-Conical / All Rounder in a Fermentation Chamber / Fridge, you will want to allow 420mm measured from the base of the ring collar to a comfortable level to pull the pressure relief valve to purge oxygen from the hop bong.

Named purely on its looks and not its function. The Hop Bong is a versatile pressurisable tri-clamp accessory, capable of not only dry hopping oxygen purged hops into fermenters but also as an inline carbonation/oxygenation accessory.

This is an upgrade kit for existing FermZilla Tri-Conical and All Rounder fermenters. Only compatible with the 2" Tri-Clamp Adapted Pressure Lid.