Disconnects and Couplers
-
$5.00 -
$13.95SIlicone check Valve for D&S coupler
SIlicone check Valve for D&S couplers.
For the larger type check valve see here -
$0.50Silicone Washer Seal - 5/8 for Keg Coupler and Tap Shank
A 5/8" silicone washer seal for Keg Coupler or Tap Shank.
Note: may come in black or white/clear.
Silicone washer seals are easier to get a proper seal but are also easier to damage. If you are looking for a more robust solution consider using a 5/8" neoprene washer instead. -
$2.95Probe Seal Washer for Keg Coupler - D Type - No.4
Gas shut off probe (Keg Coupler Probe seal o-ring No.4)
Compatible with micromatic and all 'D and S' type keg couplers.
Dimensions 17MM OD X 10MM ID
-
$3.95D Type coupler O-ring (Body O-ring) No.5
'D and S' Type coupler O-ring (Body O-ring) No.5
Normally purchased in increments of x 2. (body takes 2 o-rings)
-
$79.95Keg Coupler - 90 Degrees D-Type Low Profile - C4999
Keg Coupler - D Type (US Sankey). This is a low profile coupler designed for situations where vertical space is limited.
Includes a pressure relief valve (releases at 55 PSI).
Out of Stock -
$0.50EPDM Washer Seal - 5/8 for Keg Coupler and Tap Shank
This is a EPDM 5/8 Washer which is suitable for Keg Couplers and Tap Shanks
Specifications:
15mm ID x 21.5mm OD x 3mm -
$16.95Keg Connector - Duotight Flow Control - 8mm Liquid
Duotight 8mm x Flow Control Ball Lock Disconnect (Black-Yellow/Liquid).
This all new ball lock disconnect sets a new bar! The integrated duotight design means you can connect your beer line directly, easily and reliably - no need for additional fittings or clamps. It is a robust and super compact compared to the previous Stainless Steel Flow Control Ball Lock that has been discontinued due to the difficulty in repeated tooling and overall cost of raw materials.
-
$4.95Duotight - Seal Kit for Flow Control Keg Connector
Seal Kit - duotight 8mm x Flow Control Ball Lock Disconnect
Please refer to the product photos for an exploded diagram of where the replacement seals and poppet placement. -
$69.95Keg Coupler - D-Type Stainless with Duotight Fittings
D-Type Keg Coupler - Full 304 Stainless - with Duotight 5/8" to 8mm push fit fittings.
Includes:
1 x - D-Type Coupler with 5/8" Male Beer and Gas threads
2 x - duotight 5/8" duotight to 8mm push in
1 x - Non-Return Ball or Torpedo check piece (Non-Return Liquid)
1 x - Gas Duck Bill valve (Non-Return Gas)
