Connections and Valves
-
$14.90 -
$6.95Duotight - 9.5mm One Way Check Valve (Gas)
This elbow piece is suitable for the EVABarrier Beer & Gas line in 9.5mm (3/8") OD line to 6.3mm (1/4") ID.
-
$16.95 -
$3.45Tri-Clamp Gasket
Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.
Currently available in these sizes:
- 3.81cm (1.5")
- 5.08cm (2") (flat, not beaded)
- 5.08cm (2") - (also used as Grainfather conical plug seal)
- 7.62cm (3")
- 10.16cm (4")
- 15.24cm (6")
- 20.32 (8")
Note: photo shows 7.62cm (3") beaded option. Colour may vary.
-
$39.95Tri-Clamp Cap - 3" to 1.5" Reducer
Tri-Clamp Cap - 3" to 1.5" Reducer. Great for allow you to use existing 1.5" tri-clamp fittings on a 3" TC fermenter.
Note: 3" gasket not included.
Out of Stock -
$6.101/2" Inch BSP 316 stainless hex Back Nut
Used in conjunction with a hex nipple, washer and ball valve assembly. -
$2.50 -
$5.00SS Brew Bucket O-Ring Replacements
SS O-Ring replacements for Brew Buckets and Mini Brew Buckets.
For use on Brew Bucket 3/8" Ball Valve. Includes:
- 4 pcs 8.5 mm x 1 mm Buna N 70 O-rings
- 2 pcs 16mm x 1.8 mm Buna N 90 O-rings
- 6 pcs total in this set (enough to replace all o-rings on one Brew Bucket valve)
From: Ss Brewing Technologies, USA -
$4.00Teflon Thread Seal Tape
Teflon PTFE Thread Seal Tape for sealing threaded joints.
Size: 12mm wide x 10m
Colour: Yellow
Nobody likes leaky fittings in the brewhouse - a little bit of teflon thread tape can make all the difference. -
$19.951.5” Tri-Clamp cap with 3/8" barb
A stainless steel Tri-Clamp Cap with 3/8" Barb fitting.
Tri-Clamp (also called Tri Clover) fittings consist of 3 parts: the clamp, the end piece and a silicone gasket. Used in most commercial breweries they are very sturdy. With no nooks or crannies for bacteria/yeast to hide, they clean like a breeze.You can see every surface that meets your precious wort. If that weren't reason enough: they don't leak.
