With the Grainfather Sparge Water Heater 40L, brewers can heat and keep up to 40L of sparge water at a specified temperature until it's needed. This means they can focus on the rest of their brew day, without having to worry about how or when they're going to heat large volume of sparge water, and avoid the need to use 2 (or more) smaller volume heaters.

The unit heats up to 40L (10.6 US Gal) of sparge water in approx. 50 minutes, so brewers simply start heating during the mash, and they can forget about it until it's time to sparge.

False Bottom for Ss Brewtech kettles 76L. These false bottoms feature a centre draw / drain and have all the fittings needed included in the box so they are plug and play with standard edition Ss Brewtech kettles. They also include a silicone gasket that seals off grain from getting around the edges of the false bottom.

Works with standard edition Ss Brew Kettles - not suitable for Brewmaster Kettles.

A tri-clamp, 1/2" ball valve

- perfect for Ss Brewmaster kettles, or any 1.5" tri-clamp fitting.
- 3-piece ball valve
- 304 Stainless Steel
- 1/2" ID valve body
- 1.5" tri-clamp on one side
- 1/2" threaded NPT (female) other side

Note: does not include tri-clamp gasket, clamp or hose barb.

A dial-type thermometer that is made for the SS Brewtech Brewmaster Kettles, although it could be used in any 1.5" tri-clamp situation. 

Thermometer:

• Dial Face: 3" -
• Tri-Clamp: 1.5"
• Range: -20-120 degrees C, 0-240 degrees F
• Accuracy: +/-1%
• Stem length: approx. 6cm (2.5")

Note: does not include tri-clamp gasket or clamp.

It can be fitted to a 2 Inch Tri Clover ferrule. It does have a water-resistant screw element guard. This was produced to be used with our 118L Kegmenter that has 2" Ferrules

The 3600w Element is highly regarded as a popular and reliable element for distillers and homebrewers alike.

This element must be wired by a professional electrician.

The 25L Sparge Water Heater is designed to be used with Brewing Systems of up to 40L, making it the perfect companion for the G40 or the G30.

Designed exclusively for the 3 Vessel homebrewing market that wants to take full use of a DigiBoil to be used as a Mash Tun/Lauter Vessel. It can also be used on the BrewZilla Gen4 and 3.1.1 units if you wish.

Replacement Tap Nut for the Grainfather Sparge Water Heater 40L.

Suitable for any 1/2" tap thread. Comes with 1/2" washer and seal.