Fermenter Parts and Accessories
-
$11.50 -
$78.00Ss CIP Spray Ball Tri-Clamp Attachment 1.5"
CIP Spray Ball Tri-Clamp Attachment
- Made from 304 Stainless Steel
- 1.5" tri-clamp cap with 1/2" MPT
- 2 bar / 29 psi recommended
- Use on any 1.5" tri-clamp fittingOut of Stock -
$89.95Ss CIP Spray Ball Tri-Clamp Attachment 3"
CIP Spray Ball Tri-Clamp Attachment
- Made from 304 Stainless Steel
- 3" tri-clamp cap with 1/2" MPT
- 2 bar / 29 psi recommended
- Use on any 3" tri-clamp fittingOut of Stock -
$12.95Push In Pressure Gauge - 8mm
This push in gauge is ideal to read pressures during pressurised fermentation. The triple scale gauge gives readings in Bar, PSI and kPA so irrespective of what units you prefer this gauge will display what you need.
The barb on this gauge will enable you to put this directly onto hosing or alternatively you can connect it to any of the push in fittings such as the Duotight push in fittings in the 8mm size.
Specifications:
- 0-40psi / 0-250kPa / 0-2.5 Bar (kg/cm^2)
- Rubber Coated
- 8mm Push in Barb
From: Kegland -
$9.50Sterilock Air Lock (with one odour capsule)
The Sterilock contains a patented nanoseal that removes fermentation odours and allows C02 gases to safely vent while preventing any contaminants (including bacteria) to enter the fermentation vessel.
-
$9.50Sterilock Odour Capsules (4)
For use with the Sterilock Airlock Contains 4 odour absorbing capsules to remove fermentation odours.
Out of Stock -
$9.50Still Spirits Air Still Washers. 10 pack.
Food grade Polyethylene Washers designed for the Air Still Filter and the Air Still Fermenter Lid. Ideal for use with alcohol as Polyethylene will not taint alcohol.
Comes in a pack of 10.
-
$24.95FermZilla Plastic Pressure Kit
FermZilla Plastic Pressure Kit - suits both 27L, 55L FermZilla and All rounder fermenters.
-
$59.95FermZilla - Jacket for 55L Fermenter
This jacket is designed to insulate your FermZilla 55L fermenter during the colder months to keep your fermentation at the optimum temperature. It can also be used with a heater belt to warm up the wort if the heat from the fermentation isn't enough.
It also completely blocks any light/UV to prevent light stuck beer.
From: Kegland -
$64.95Temp Twister Cooling/Heating Coil for FermZilla
The Temp Twister allows you to heat and cool your FermZilla or other fermenter or bright tank, ideally by combining with a glycol chiller.
This coil can be adapted to fit any fermenter or bright tank that has an opening of 110mm diameter or larger. Simply drill to two 22mm holes in the lid of your fermenter and use the included Duotight bulkhead fittings to attach the coil to the lid of your fermenter.
